Full Gut Reno- 3 family house- Queens
Started by steve0199us_2126619
about 9 years ago
Posts: 1
Member since: Jan 2017
Discussion about
Hello- I am looking into a full gut reno on my frame house, the house is detached on both sides and the foot print is 20x60(about), lot is about 20x100, no walkway on either side. I am in the very early stages, have lots of research to do on financing, architects and potential design (within the R5-d zone). I am leaning towards a gut reno- tear down the walls, floors, move walls/kitchen/bathrrom... [more]
Hello- I am looking into a full gut reno on my frame house, the house is detached on both sides and the foot print is 20x60(about), lot is about 20x100, no walkway on either side. I am in the very early stages, have lots of research to do on financing, architects and potential design (within the R5-d zone). I am leaning towards a gut reno- tear down the walls, floors, move walls/kitchen/bathrrom and rooms, upgrade electrical wires/water+gas pipes and try to upgrade modernize where it would make sense, sister/reinforce beams and stilts and possibly extend the home in the rear from level 1 through 3. and, maybe add a greenspace sort of roof (not even sure if this would be do-able) it is a lot of work, I was hoping someone here has recently done something similar on the forum and could point me in the right direction in terms of recommendation (architect, construction companies to consider) and other points to take into consideration. Lastly, I know cost is a huge variable depending on many factors... I am not looking to do anything high end, aiming to be in the middle ground of $$$. What do you think a ballpark range would cost for this in Queens? [less]
Is there a particular reason you are looking to do a gut reno on a stick house rather than a tear down?
Steve,
I can give you some architects that can help you. Feel free to email me at primerenovations@mac.com
Hi- I believe if I did a tear down my grandfathered building codes would be given up
sorry for the delay response, I did not realize the posting was approved for the forum since I am a new member.. thanks for the input